RZ-G/RZ-G2L SMARC: Difference between revisions
No edit summary |
No edit summary |
||
Line 3: | Line 3: | ||
== General Information == | == General Information == | ||
* [https://www.renesas.com/us/en/products/microcontrollers-microprocessors/rz-arm-based-high-end-32-64-bit-mpus/rzg2l-general-purpose-microprocessors-dual-core-arm-cortex-a55-12-ghz-cpus-3d-graphics-and-video-codec Official RZ/G2L Website ] | |||
* [https://www.renesas.com/us/en/products/microcontrollers-microprocessors/rz-arm-based-high-end-32-64-bit-mpus/rzg2l-general-purpose-microprocessors-dual-core-arm-cortex-a55-12-ghz-cpus-3d-graphics-and-video-codec Official | ** Please review the '''Documentation & Downloads''' section | ||
* Linux Board Support Package Download | |||
** Please refer to the '''[https://www.renesas.com/us/en/products/microcontrollers-microprocessors/rz-arm-based-high-end-32-64-bit-mpus/rzg2l-board-support-package-419-cip Linux BSP page]''' and read the '''Release Note''' document for the BSP build instructions | |||
* Additional Help | |||
** A script for programming the boot loaders into SPI Flash can be found here: https://github.com/seebe/rzg_stuff/blob/master/boards/rzg2l_smarc/README.md | |||
== Board Documentation == | == Board Documentation == |
Revision as of 13:49, 5 May 2021
β RZ-G
General Information
- Official RZ/G2L Website
- Please review the Documentation & Downloads section
- Linux Board Support Package Download
- Please refer to the Linux BSP page and read the Release Note document for the BSP build instructions
- Additional Help
- A script for programming the boot loaders into SPI Flash can be found here: https://github.com/seebe/rzg_stuff/blob/master/boards/rzg2l_smarc/README.md
Board Documentation
Board Setup Information
Board Operation Information
Power ON β Connect USB-PD Power Charger to USB Type-C Connector. Then LED1(VBUS PWR On) and LED3(Module PWR On) lights up. β Press SW9 to turn on the power. Then LED4(Carrier PWR On) lights up. |
Debug Serial (Console Output) β Debug serial uses CN14. The baud rate is 115200bps. β Since the serial-USB conversion IC is not always powered, the Windows PC will recognize it after the power switch is turned on. β If it is not recognized by your Windows PC, please install the driverοΏ½https://www.ftdichip.com/Drivers/VCP.htm |