RZ/G2L SMARC Board by Renesas

From Renesas.info

RZ-G

General Information

Board Setup Information

board configuration.png
RZ/G2L Evaluation Board Kit Configuration
smarc module board top.png
RZ/G2L SMARC Module Board (TOP)
smarc module board bottom.png
RZ/G2L SMARC Module Board (Bottom)
smarc series carrier board.png
RZ SMARC Series Carrier Board
 
power supply.png
Power Supply
The following power supply environment is used in the evaluation of Renesas:
● USB Type-C cable CB-CD23BK (manufactured by Aukey)
● USB PD Charger Anker PowerPort III 65W Pod (manufactured by Anker)
JTAG connection ice debug.png
JTAG Cable Connection for ICE Debugging
When connecting JTAG debugger, please set the DIP SW1 settings as shown.
The JTAG connector is 10pin.
 
boot mode.png
How to set Boot Modes

Board Operation Information

power on.png
Power ON
● Connect USB-PD Power Charger to USB Type-C Connector. Then LED1(VBUS PWR On) and LED3(Module PWR On) lights up.
● Press SW9 to turn on the power. Then LED4(Carrier PWR On) lights up.
debug serial.png
Debug Serial (Console Output)
● Debug serial uses CN14. The baud rate is 115200bps.
● Since the serial-USB conversion IC is not always powered, the Windows PC will recognize it after the power switch is turned on.
● If it is not recognized by your Windows PC, please install the driver�https://www.ftdichip.com/Drivers/VCP.htm