RZ/G2L SMARC Board by Renesas

From Renesas.info
Revision as of 18:17, 29 April 2021 by Padhikari (talk | contribs)

← RZ-G

General Information

Board Documentation

RZ/G2L Evaluation Board Kit Configuration

board configuration.png

RZ/G2L SMARC Module Board (TOP)

smarc module board top.png

RZ/G2L SMARC Module Board (Bottom)

smarc module board bottom.png

RZ SMARC Series Carrier Board

smarc series carrier board.png

Power Supply

The following power supply environment is used in the evaluation of Renesas:

  • USB Type-C cable CB-CD23BK (manufactured by Aukey)
  • USB PD Charger Anker PowerPort III 65W Pod (manufactured by Anker)

power supply.png

Power ON

  • Connect USB-PD Power Charger to USB Type-C Connector. Then LED1(VBUS PWR On) and LED3(Module PWR On) lights up.
  • Press SW9 to turn on the power. Then LED4(Carrier PWR On) lights up.

power on.png

JTAG Cable Connection for ICE Debugging

  • When connecting JTAG debugger, Please set the DIP SW1 settings as follows. JTAG connector is 10pin.

JTAG connection ice debug.png

How to Set Boot Mode

boot mode.png

Debug Serial (Console Output)

  • Debug serial uses CN14. The baud rate is 115200bps.

debug serial.png

  • Since the serial-USB conversion IC is not always powered, the Windows PC will recognize it after the power switch is turned on.
  • If it is not recognized by your Windows PC, please install the driver�https://www.ftdichip.com/Drivers/VCP.htm
Retrieved from "https://renesas.info/w/index.php?title=RZ-G/RZ-G2L_SMARC&oldid=133"