RZ-G/RZ-G2L SMARC: Difference between revisions
No edit summary |
|||
Line 15: | Line 15: | ||
* Articles | * Articles | ||
** [http://linuxgizmos.com/renesas-adds-to-rz-g2-line-with-three-cortex-a55-socs Renesas adds to RZ/G2 line with three Cortex-A55 SoCs] | ** [http://linuxgizmos.com/renesas-adds-to-rz-g2-line-with-three-cortex-a55-socs Renesas adds to RZ/G2 line with three Cortex-A55 SoCs] | ||
= Getting Started = | |||
1. '''Download the Linux BSP''' : Download the Linux BSP from renesas.com. More information can be found [https://renesas.info/wiki/RZ-G/RZ-G2_BSP here] | |||
2. '''Build Environment''' : To build the BSP, you will need a Linux PC running Ubuntu 20.04. | |||
3. '''Build the BSP''' : The instructions for building the BSP are located in the "Release Note" document that is include in the BSP download. | |||
4. '''Prepare an SD Card''' : The evaluation boards are intended to be booted from SD Cards. These cards must be formatted and loaded using a Linux PC. A helpful script has been created ([https://github.com/renesas-rz/rzg2_bsp_scripts/tree/master/usb_sd_partition usb_sd_partition]) that you can run on your Linux PC. | |||
5. '''Boot the Board''' : After formatting and loading the SD Card and inserting it into the SOM board, the board will automatically boot into Linux after Power On Reset. The login will be "root" (no password is needed) | |||
= Board Setup Information = | = Board Setup Information = |
Revision as of 13:17, 7 July 2021
β RZ-G
General Information
- Official RZ/G2L Website
- Please review the Documentation & Downloads section
- Board Documentation
- Linux Board Support Package Download
- Official BSP Download Page
- Please refer to the Linux BSP page and read the Release Note document for the BSP build instructions
- Additional Help
- A script for programming the boot loaders into SPI Flash can be found here: https://github.com/seebe/rzg_stuff/blob/master/boards/rzg2l_smarc/README.md
- Articles
Getting Started
1. Download the Linux BSP : Download the Linux BSP from renesas.com. More information can be found here
2. Build Environment : To build the BSP, you will need a Linux PC running Ubuntu 20.04.
3. Build the BSP : The instructions for building the BSP are located in the "Release Note" document that is include in the BSP download.
4. Prepare an SD Card : The evaluation boards are intended to be booted from SD Cards. These cards must be formatted and loaded using a Linux PC. A helpful script has been created (usb_sd_partition) that you can run on your Linux PC.
5. Boot the Board : After formatting and loading the SD Card and inserting it into the SOM board, the board will automatically boot into Linux after Power On Reset. The login will be "root" (no password is needed)
Board Setup Information
Board Operation Information
Power ON β Connect USB-PD Power Charger to USB Type-C Connector. Then LED1(VBUS PWR On) and LED3(Module PWR On) lights up. β Press SW9 to turn on the power. Then LED4(Carrier PWR On) lights up. |
Debug Serial (Console Output) β Debug serial uses CN14. The baud rate is 115200bps. β Since the serial-USB conversion IC is not always powered, the Windows PC will recognize it after the power switch is turned on. β If it is not recognized by your Windows PC, please install the driverοΏ½https://www.ftdichip.com/Drivers/VCP.htm |