RZ-G/RZ-G2L SMARC: Difference between revisions
No edit summary |
|||
Line 2: | Line 2: | ||
β [[RZ-G]] | β [[RZ-G]] | ||
= General Information = | |||
* [https://www.renesas.com/us/en/products/microcontrollers-microprocessors/rz-arm-based-high-end-32-64-bit-mpus/rzg2l-general-purpose-microprocessors-dual-core-arm-cortex-a55-12-ghz-cpus-3d-graphics-and-video-codec Official RZ/G2L Website ] | * [https://www.renesas.com/us/en/products/microcontrollers-microprocessors/rz-arm-based-high-end-32-64-bit-mpus/rzg2l-general-purpose-microprocessors-dual-core-arm-cortex-a55-12-ghz-cpus-3d-graphics-and-video-codec Official RZ/G2L Website ] | ||
** Please review the '''Documentation & Downloads''' section | ** Please review the '''Documentation & Downloads''' section |
Revision as of 17:55, 29 June 2021
β RZ-G
General Information
- Official RZ/G2L Website
- Please review the Documentation & Downloads section
- Linux Board Support Package Download
- Please refer to the Linux BSP page and read the Release Note document for the BSP build instructions
- Additional Help
- A script for programming the boot loaders into SPI Flash can be found here: https://github.com/seebe/rzg_stuff/blob/master/boards/rzg2l_smarc/README.md
- Articles
Board Documentation
Board Setup Information
Board Operation Information
Power ON β Connect USB-PD Power Charger to USB Type-C Connector. Then LED1(VBUS PWR On) and LED3(Module PWR On) lights up. β Press SW9 to turn on the power. Then LED4(Carrier PWR On) lights up. |
Debug Serial (Console Output) β Debug serial uses CN14. The baud rate is 115200bps. β Since the serial-USB conversion IC is not always powered, the Windows PC will recognize it after the power switch is turned on. β If it is not recognized by your Windows PC, please install the driverοΏ½https://www.ftdichip.com/Drivers/VCP.htm |